Пошаговое применение (фото)

Preserving a Tarantula is as easy as 1,2,3.

Preserving a dehydrated Tarantula is fast and easy with Encapso® K silicone encapsulation rubber. When cured, Encapso® K looks just like water and will last a long time. This Non-Hazardous – 2 part silicone rubber is easy to use, UV resistant and cures without generating any dangerous heat or fumes. 

  • 1 - начало
  • 2 - продолженгие
  • 3 - Equal amounts of Part A and Part B, are measured by volume.
  • 4 - Combine Encapso® K Parts A and B in a container and mix thoroughly.
  • 5 - Since the Tarantula will float, a small about of Encapso® K is poured into the container covering ½ of the legs and the lower section of the body only.
  • 6 - Allowed Encapso® K to cure to a 'gel' state, approximately 1.5 hours before continuing.
  • 7 - Measure and mix a second batch of material. Slowly pour to the lowest point of the container. Allow the liquid to flow around the Tarantula covering the highest point by ½ inch.
  • 8 - Any residual bubbles on the surface will dissipate. Allow the Encapso®K to cure overnight.
  • 9 - When cured, the water clear Encapso® K allows viewer to see every aspect of the Tarantula.
Продукты, использующиеся в этой статье
Категория Продукт
Полупрозрачные на олове Encapso K